HOLDEN V6 INTO JACKAROO WITH DRIVERS SIDE CLUTCH AP088 - HOLDEN - ADAPTOR PLATE

HOLDEN V6 VN-VT ENGINE INTO RODEO AND JACKAROO WITH 4CYL ENG AND DRIVERS SIDE CLUTCH THIS KIT WILL NOT SUIT A RODEO/JACKAROO WITH A HYDRAULIC CLUTCH SLAVE CYLINDER LOCATED ON THE PASSENGER SIDE OF THE BELLHOUSING. YOU WILL NEED A DIFFERENT ADAPTION KIT CONTACT CRS FOR DETAILS.

ADAPTION KIT CONTAINS:

1 off Adaptor plate AP088 fitted with (1) off 11-mm x 25 long dowel – AP 88

1 off 11mm x 25 long dowel to be fitted to adaptor according to instructions – Step no. 4 2 off M12 x 1.75P x 50 long counter sunk head unbrako bolt – adaptor to motor

3 off M12 x 1.75P x 30 long counter sunk head unbrako bolt – adaptor to motor

1 off M12 x 1.75P nut with flat and spring washer – adaptor to motor

2 off 3/8” UNC x 1-1/2” bolts with flat and spring washers – transmission to adaptor

2 off 3/8” UNC x 1-3/4” bolts with flat and spring washers – transmission to adaptor

3 off 3/8” UNC x 1-1/4” bolts with flat and spring washers – transmission to adaptor

1 off 5/16 UNC x 1-1/4” bolt with flat and spring washers – transmission to adaptor

1 off Dust Cover – Part no. - Dust 22 6 off M6 x 1.0P x 16 long bolts with flat and spring washers (Dust cover to adaptor)

1 off Thrust bearing extension - Part no. - TE 04

1 off Thrust bearing to suit - NSK Part no. TK 45 - 4BUS3 (Ford Bear 02)

1 off Clutch Plate PBR Part no. - 10099W (CP 31)

1 off Spigot bearing kit to suit the motor you are using, see attached sheet for details. Drawing number CRS 2151.